AMC Mecanocaucho

The AMC-Mecanocaucho® SCHR type mounts are made of two parts of rubber, one of which bears an inside metal bushing which acts as a guide through the machine anchoring screw. It is installed pre-compressed on the actual machine frame, whose thickness “T” determines the degree of precompression.

Moreover it contains a metallic part, that avoids a premature wear by friction between the rubber and the housing of the mount.

Technical characteristics

Washers should be used, if the rubber surface is not covered with the contact surface

Applications

Vehicle cabins
Public works and agricultural vehicles, etc.

Dimensions

Type	Weight(kg)	Ø ext.(mm)	Ø int.(mm)	Thickness(mm)	Code
SCHR 35	0,016	38	8,5	2	610053
SCHR 50	0,05	54	12,5	3	611080
SCHR 65	0,125	67	16,5	5	606130

Dimensions

Type	Weight(kg)	Ø ext.(mm)	Ø int.(mm)	Thickness(mm)	Code
SCHR 90	0,312	95	22	6	608101
SCHR 125	0,58	145	25	8	610123
SCHR 140	1,251	145	30	10	608115

Operation and Assembly

The SCHR mounts should be assembled according to the following installation instructions. There are two possible configurations, see previous assembly picture. They can be installed in plates of different thicknesses according to the Tmx and Tmin values given in the Table provided . The load vs deformation curves will vary according to the plate thickness in which the mount will be installed.

Washers should be used, if the rubber surface is not covered with the contact surface.

SCHR WASHER

Technical characteristics

Applications

Dimensions

Dimensions

Elastic properties

Operation and Assembly